peterbilt 359 analog water temp gauge

• 2022-10-11

Our water temp gauge is analog auto gauge , can use on different types of vehicles , such as peterbilt 359 . The normal temperature of peterbilt 359 water temperature is 80-90 ℃. Too high or too low will adversely affect the normal operation and performance of the engine. The reason may be that there is no change in the analog water temp gauge after running dozens of kilometers, and the circuit of the peterbilt 359 analog water temp gauge is faulty. The heating coil of the water temperature gauge is burnt out and the circuit is in poor contact. The water temperature sensor is damaged. Therefore, the temperature signal of the water temperature cannot be detected, so the pointer of the water temperature gauge will not move. It may also be caused by burnt sensor heating coil or poor contact. The instrument panel water temperature gauge itself is broken, the pointer does not move, and the water temperature gauge needs to be replaced. But in the actual situation, we can't see the real car, so we can't accurately judge the cause of the vehicle accident. For the sake of safety, we suggest that you should go to a professional car repair shop in time to repair, let professionals check the problem, eliminate the vehicle problem, and ensure the safety of drivers and passengers.

If peterbilt 359 analog water temp gauge has problem , can change a new one from our company. Ours are suitable. First, check whether the wire ends are broken or loose. If it is OK, the water temperature sensor instrument is broken. You can unplug the water temperature sensor and place the plug on the wire. Turn on the key and look at the thermometer on the instrument every time you turn it. If the water temperature sensor is broken, do not replace the instrument. The power line of the water temperature gauge is disconnected, the electric heating coil of the water temperature gauge is burnt out, and the electric heating coil of the water temperature gauge sensor is burnt out or has poor contact. The water temperature gauge sensor wire is improperly connected or disconnected. The voltage regulator that provides stable power to the circuit of the water temperature gauge is damaged. You try the heating is hot. And the temperature of the upper tube and the lower tube is the same. It is recommended to check whether there is a thermostat. Then , if the analog water temp gauge or sensor problem , can contact us , we can support them.