programmable led fuel level gauge for honda prelude
For programmable led fuel level gauge for honda prelude's oil dipstick is quite accurate. Try not to wait until the oil gauge reaches the red line before refueling, as this will damage the service life of the oil pump. To meet the aesthetic needs of contemporary fashion
How to check:After ignition, observe the position of the pointer on the right oil gauge. If the oil is filled, the pointer will turn to the blue position, usually to the red line, and there is almost no oil.The fuel gauge only shows a rough figure, which means how many kilometers the fuel in the fuel tank can travel safely under the current average fuel consumption. This figure will change according to your comprehensive fuel consumption. However, if the mileage displayed on the instrument is close to zero, there are about five liters of fuel in the fuel tank, which can be used to drive you to the nearest gas station for refueling. It's not that I can't run after zero, but I can refuel in advance.
Honda CRV has a rotatable button on the dashboard. You can press it to switch between the three display modes. The latter two display modes have fuel consumption. Press the button and rotate it to clear the data. Of course, the total kilometers cannot be cleared. The detailed display method of fuel consumption per 100 km is as follows: Method 1: 1. There is an adjustment button on the wiper switch on the right side of the steering wheel to select the fuel consumption display. 2. Press and hold the top of the wiper switch for 2 seconds to enter the selection interface to see the options.Method 2: press and hold the OK key, turn the key door to the first gear, and do not start the engine. After holding for a few seconds, observe the display change of the instrument panel and press the OK key continuously until the fuel consumption reaches 100 km. Stop and start the engine when the fuel consumption is 100 km, and the instrument panel will always display the fuel consumption of 100 km.
Get a Quote / Info