the best way to install aftermarket water temp gauge

• 2022-09-24

It is obvious that the water supply pipe is generally 28mm in the carriage. The length of the cut-out opening at the appropriate position shall be as close as possible but not more than the length of the tee. Next, thread the wire of the aftermarket water temp gauge from the left side of the driver's seat to the engine compartment and connect it to the sensor. At the same time, connect the wire of the water temperature gauge to the wire in the middle of the cigarette lighter and the other two wires respectively, so as to form a circuit with it. After pulling out the key, it can automatically cut off power, which is very convenient. The installation of the aftermarket car water temperature gauge is completed. However, after the car is mainly equipped with the aftermarket car water temp gauge, it is necessary to observe the mechanical working state at any time in the early stage. If the temperature reaches about 99 degrees, the electronic fan will not start. The owner will quickly turn off the engine and open the cover of the machine for a rest, and wait for a buffer time.

There are a lot of cars without aftermarket water temp gauges. In fact, it's just a reminder in another way! Generally speaking, the instrument panel of an automobile is not equipped with a water temperature gauge, and there will be an indicator light to remind. When the water temperature is low, it will generally indicate low temperature. When the water temperature of the vehicle reaches 40 ℃, the indicator light of the low-temperature instrument goes out, indicating that the vehicle can drive normally at this time. When the water temperature reaches the high temperature alarm temperature, it will prompt that the water temperature is too high at an obvious position!

The engine water temperature is an important parameter of automobile performance. If the engine water temperature is too high during driving, the water temperature gauge will light up. At this time, stop the engine, unload the engine load, but do not extinguish the fire. Turn off the engine after 5 or 6 minutes in the idle state of the engine. Wait until the water temperature slowly drops down and the water temperature indicator enters the normal state, and then start the vehicle to continue driving.