English 
yamaha bolt speedometer relocation
The idle speed adjusting screw is on the right side of the carburetor (that is, the car). The idle speed should be adjusted when the car is hot, and the idle speed when the car is hot should be taken as the standard. Start the engine to warm up. When the engine temperature rises to normal, turn the idle screw left and right until the idle speed is normal (about 1500 rpm). The right mixture screw should not be adjusted easily. The idle speed is based on the hot car. When the car is cold, the idle speed will automatically become lower. This is a normal phenomenon. It is only necessary to properly cooperate with the throttle valve and accelerator to start and warm up. If it is invalid to adjust the idle speed repeatedly, check whether the mixing ratio is incorrect, whether the carburetor is blocked, whether the spark plug is poor, etc.Screws are tools that use the physical and mathematical principles of the circular rotation of the inclined plane of objects and the friction force to tighten the artifacts and parts step by step. The screw is mainly used to connect two work pieces together for fastening. Screw is also called "Screw" (screw) or "Screw" (screw rod). In fact, screws are general terms, while screws and screw rods are different from each other.
How to set Yamaha bolt speedometer relocation:
Set the tray mode and teach the coordinates of the four points P1P2P3P4. If you want to execute the specific points below, you need to use the following command PMOVE (1, 16)..................................... The main robot axis moves the PMOVE (1, A%) integer A% from the current position to the position specified in the tray position No. 16 of the tray definition No. 1 plus 1, so that you can place it in order, or the position is controlled by the upper computer. If there is an exception, The placement position can be changed in real time, and the command of the whole tray mode is almost there.Yamaha cylinder shall be scraped according to the coloring of red lead on the joint surface of lower cylinder. This method is suitable for high pressure cylinders with strong structural rigidity. It is the bolt that tightens the joint surface. Check the tightness of the joint surface according to the feeler gauge, measure the value and the pressed trace, and repair the joint surface. This method can eliminate the influence of Yamaha cylinder vertical arc on the clearance.
Get a Quote / Info