how to mount water temp gauge in my 95 ford f150

• 2022-09-07

The 95 Ford F150 does not have a water temp gauge and can be mounted with a water temp gauge by itself. First of all, the owner had better find the water supply pipe of the car. The general position is very obvious, and the owner can easily see it. Next, cut the opening at the appropriate position. Install the tee into the water supply pipe and fix it with a lock. At the same time, screw the sensing head on the small mouth. Finally, apply sealant to the gap. Then, thread the wire of the water temperature gauge from the left side of the driver's seat to the engine compartment and connect it to the sensor sending unit. At the same time, connect the wire of the water temperature gauge to the wire in the middle of the cigarette lighter and the other two wires respectively, so as to form a circuit with it. The owner can automatically cut off the power after pulling out the key, which is very convenient. At this point, the installation of the automobile water temperature gauge is completed. After the installation of the automobile water temperature gauge, observe the mechanical working state in the early stage. If the temperature reaches about 99 degrees, the electronic fan will not start. The driver will quickly turn off the engine and open the cover of the machine for a rest and wait for a buffer time.

The water temperature gauge is actually telling you the "temperature" of the current car, so that you can better choose the driving mode. For example, when the water temperature is low, the car is already hot, or when the water temperature is high, the wind blown by the warm air will not be very cold. The water temperature meter of the automobile is a direct reaction display platform of the cooling water temperature of the automobile. It can provide real-time information of the driver's engine water temperature, which is expressed as the water temperature. The low water temperature will increase the fuel consumption of the vehicle and accelerate the wear of the engine. If the water temperature is too high (generally, there is a prompt, the red light of the water temperature is too high or the engine will automatically shut down), the engine will knock, and the engine will be scrapped seriously. It is important because without a water temperature gauge, it is impossible to understand the water temperature during the operation of the engine and whether the water temperature in the water tank is abnormal.