mercury smartcraft gauge not showing trim position

• 2022-04-19

Energize: Each gauge will energize when the ignition key is turned to the "ON" position. Just the ignition switch with the key in the "ON" position, all meters will be energized.

Brightness: Both brightness and contrast can be adjusted.

Buttons: The "MODESELECT" key is used to select the displayed information; the "+" and "-" keys are used to set the engine speed and the calibration of the instrument during the flight control process.

Trolling Control: Allows the driver to set and control the idle speed of the engine for trolling without having to change the throttle. (system tachometer and system speedometer)

Cruise Control: Set and control the speed of the boat while cruising. (SmartTow Tachometer)

Thrust Control: Sets and controls acceleration from idle state to set cruise speed.

Engine Guardian System: Monitors the critical sensors of the engine to display faults in advance. The system responds to failures the countermeasure is to reduce the engine speed to maintain safe operation.

Alarm system: The system makes the alarm buzzer sound and displays the alarm information.

The SmartCraf alarm system allows the display (a) to work in conjunction with the alarm buzzer and the Guardian protection system.

Alarm buzzer installed in the remote control, or forms part of the ignition key switch wiring harness.Audio alarm - when a problem is detected, the alarm buzzer will sound and the name of the fault alarm will be displayed.

If the problem can cause immediate damage to the engine, a buzzer will sound continuously, and the Engine Guardian system (b) will take action on the problem.

The countermeasure is to reduce the engine output power. The accelerator should be closed immediately and the speed should be reduced to idle speed.

If the problem does not cause immediate engine damage a buzzer will sound, but not continuously. Please review the "Alarm Messages" below and what actions to take.

If the MODE key is not pressed, the alarm will always be displayed. If there are multiple alarm failures, these alarms will be displayed cyclically every 5 seconds. Pressing the MODE key will change the display content. For example, the upper right corner still flashes the alarm signal "AL" (c), indicating that the problem has not been eliminated.