oil temp gauge all the way on audi a4

• 2022-11-29

The central control instrument can be seen. Audi cars do not have an oil dipstick. Look through the display screen inside the car. Press the car key to select the oil level. Check the conditions: the engine oil temperature is above 60 degrees. Turn off the engine. After 1 minute, turn on the ignition switch to see it. On the display screen, press CAR to see it! At the same time, if the car is short of oil, an icon like an oil pot will be displayed on the instrument panel. If this icon is not available during normal driving, it means that no oil needs to be added.

Audi series, how to measure with a special oil dipstick. Some engines are equipped with an organic oil dipstick, which has a maximum value of MIN and a minimum value of MIX. The oil dipstick is inserted to the bottom. When the oil dipstick is viewed at a 45 degree angle, the oil between the maximum and minimum values is normal and cannot exceed the maximum value. In addition, some engines do not have oil dipstick, so we use T40178. If it is T40,178, the scales are different for different engine models. For example, the upper ring of CUJ engine is adjusted to 32, and the lower scale is 27; CDZ: upper ring 39, lower scale 24; The upper ring of CLX engine is 132, and the lower scale is 13.

1. After changing the oil, when the car needs to be refueled to normal temperature, turn off the engine and wait for about 2 minutes to measure the oil. The engine oil temperature needs to reach above 60 degrees, that is, start CAR for more than 10 minutes, and then shut down the engine for 1 minute. On the display screen of the central control unit, press CAR to see it.

2. If the vehicle is short of oil, there will be an icon on the instrument panel like an oil pot. If the amount of oil added exceeds the official standard (usually 5L), please reset the oil maintenance lamp first. Once the oil is reset, the display screen will immediately show that the oil quantity is too much, and the instrument will not show that the oil quantity is insufficient, so it is necessary to pump the oil to the standard value.