2012 honda civic si how to connect water temp gauge to cars dash lights

• 2023-05-18

The function of car 2012 honda civic si dash is to help drivers keep track of the working conditions of the main parts of the car at all times. The gauge can connect to cars dash lights. Car repair shops are responsible for maintenance, repair, and the use of new batteries, as well as heating and ventilation devices, electric seat movement mechanisms, and generators that serve as power sources for electrical appliances. The function of a battery is to. A speed odometer is an instrument used to indicate the speed and accumulated mileage of a car. It consists of two parts: a speedometer and an odometer. The most commonly used is an electromagnetic ammeter, which simplifies the circuit and achieves good results. Some high-end cars abroad use electronic heaters. 

The 2012 honda civic si water temp gauge sensor is wired according to the positive and negative poles. 1. Firstly, locate the water temperature sensor in the engine compartment of the car, which is usually located on a water pipe interface on the engine block. The appearance of a sensor is usually a small device connected by a plug. 2. Pull off the connecting wire on the sensor plug, and you can see that there are two metal feet on the sensor plug, which are the positive and negative poles. There is usually a resistor on the positive pin to protect the sensor. Find the water temp gauge on the vehicle's dashboard and check the wiring of the water temp gauge. Connect the positive wire of the sensor to the sensor wiring port of the water temperature gauge. 3. Connect the negative wire of the sensor to the ground wire of the vehicle. 4. After the wiring is completed, the vehicle can be started and the display of the water temperature gauge can be observed. If the display is normal, it indicates that the sensor wiring is correct and can operate normally. 

When checking the 2012 honda civic si water temp sensor and water temperature indicator, the wiring on the sensor can be removed and the resistance between the sensor input terminal and ground can be measured. If the resistance value of the thermistor at room temperature is around 100 Ω,it indicates that the sensor is in good condition. When the power is turned on, if the needle of the water temp gauge is between 60 ℃ and 70 ℃, it indicates that the water temp indicator is in good condition.