water temp gauge kit snowmobile

• 2022-10-28

The snowmobile water temperature gauge kit is used to indicate the temperature of the engine cooling water. Because of the electronic fan, the water temperature of modern cars is relatively stable, and it is difficult for modern cars to start cooking. The consequences of "boiling" and running without water in the water tank are: the cylinder is pulled lightly, and the cylinder block is stuck with the piston; There are two conflicting views: the starting requirement is to reach the corresponding water temperature; The engine must not be hot for too long or carbon deposits may occur. But the corresponding temperature can't be seen from the water temperature gauge - because the pointer of the water temperature gauge will not move if the water temperature of modern cars does not exceed 50 degrees. In this case, it is better to refer to the corresponding weather and the time of arrival.

At the beginning of startup, the water temperature is low , and then slowly rises . Generally , the vehicle will automatically control its temperature to make it reach equilibrium when it is heated to about 90 ℃. At this time, the working efficiency of the engine is the highest.

If the water temperature of the snowmobile is high, the engine will not be cold and the engine will soon be scrapped. Generally, the motorcycle oil is changed every 3000 kilometers. The water temperature gauge of the water-cooled motorcycle fluctuates from high to low. It is likely that the water temperature gauge itself is broken or its wiring is poorly connected, because the water temperature is unlikely to change too quickly from high to low. Check the water temperature gauge and wiring first.

The snowmobile water temperature gauge kit should have three wires. I don't know what color your wire is. For now, it's called A (positive pole of power supply), B (negative pole of ground wire power supply) and C (sensor wire). During commissioning, connect the positive pole and negative pole of the power supply to both ends of the battery respectively, and short-circuit the sensor wire and negative pole wire. When there is no short circuit, the pointer is at the low temperature. After the short circuit, the pointer is at the highest temperature. This means that the debugging is correct, and the sensor wire can be connected to the temperature sensor probe.