Get the Best Boat Instrument Panel for Your Next Adventure. Shop Now!

• 2023-02-28

Our gauge instrument panel can be used on boat , marine and yacht. Get the best boat instrument panel for your next adventure from us. The boat instrument panel size is 300*190mm. Some customers not need panel , can only buy the separate boat gauges.

The boat instrument panel gauges can be selected by customers. If you need tachometer , can put it in. Normally customers use 3000RPM tachometer. The rotational speed of the motor is related to the power. The smaller the power, the smaller the rotational speed, the greater the power, the greater the rotational speed. For example, the synchronous speed of 1500RPM motor changes from (1410-1485) RPM when the power changes from (0.55-315) KW, while the speed of 3000RPM motor changes from (0.55-315) KW to (2830-2985) RPM when the power changes from (0.55-315) KW, so 1440RPM and 2900RPM are only one of them. 2： The motor speed is related to the slip rate. If the slip rate is different, the rated speed of the motor is different under the same synchronous speed. For example, a motor with high slip rate will have a much lower speed under the same conditions. The higher the turn-off rate, the lower the speed of the motor.

Pay attention to the control of speed: for the running-in and maintenance of the engine, the lubricating oil with good quality should be selected, and then various operations such as oil feeding, starting, gear shifting and braking should be slow and slow; Finally, the engine speed should be controlled at 2000-3000 rpm (gasoline engine). For small boats, it is better to control the speed below 3000 rpm. If the engine speed is high , some parts will be strained, and if the speed is too low and the gear is too high, the parts will be worn.

Running in the running-in period is not to control the speed of the boat, but to control the speed of the engine. The engine load is the lightest when the engine speed is controlled between 2000-3000 rpm (gasoline engine). Due to poor lubrication during the running-in period, too high speed is easy to pull parts . The speed is too low (too high gear), and the power of the engine to work becomes impact , which will also cause wear. Therefore, the engine speed must be controlled .