boat gauge lights not working

• 2023-01-09

If the boat's instrument panel gauge light is not working : First check the power supply fuse of the instrument panel, and replace it if it is blown. Then the instrument panel gauge light may be damaged. Disassemble the instrument panel. The lamp is usually at the rear of the instrument panel. Replace the lamp that does not work.

The reason why the ship's instrument lamp does not light up is that the connector has poor contact, the luminous tube has fault, and the dial circuit has open circuit fault:

1. The plug-in has poor contact, causing the automobile instrument lamp not to light up. If the plug-in is in poor contact, it will cause the instrument to be unable to power on normally and the lamp will not light up. For this problem, the general solution is to find the place with poor contact and plug it again to solve the problem .

2. The light emitting tube fails, causing the boat instrument gauge lights not working. If the light emitting tube fails, it will directly cause the meter lamp not to light up. For this problem, the general solution is to replace a new light tube, which can solve the problem .

3. There is an open circuit fault in the dial circuit, which causes the indicator light of the ship's instrument not to light up. If there is a fault in the circuit of the instrument panel, the instrument will not be powered on normally, and the lamp will not light up. For this problem, the general solution is to find the circuit first, and then repair the fault to solve the problem.

When the boat gauge light is on, immediately observe the odometer. If the accumulated mileage reaches or exceeds 100000 km, the timing belt must be replaced, otherwise the timing belt may break, making the engine unable to work normally. After replacing the new timing toothed belt, remove the rubber stopper outside the reset switch on the odometer dial, and press the reset switch inside with a small round bar to turn off the timing toothed belt indicator. If the indicator does not turn off after the reset switch is operated, it may be that the reset switch is out of order or the circuit is grounded. Repair and eliminate the fault. After replacing the new timing toothed belt, remove the odometer and adjust all readings on the odometer to 0.