English 
ford ranger oil pressure sensor replacement
It was reported that there was a problem with the 2019 Ford Ranger. It is said that technicians will have to remove the left front wheel of the new medium-sized pickup truck to replace the oil filter of the 2.3-litre turbocharged four cylinder pickup truck. A few days ago, Mike Levine, a public relations officer at Ford, told reporters on Twitter that this issue was not accurate. According to the initial report from The Truth About Cars, Ranger's 2.3-litre turbocharged engine is slightly different from that of Ford Mustang, Fox RS and Lincoln MKC. Due to the larger oil cooler in Ranger, the oil filter protrudes from the left side of the engine at a 90 degree angle rather than near the oil pan. According to the report, this means that the owner must remove the entire wheel to remove the filter. This sounds troublesome.
However, Levine described the actual process of changing Ranger oil filter in Autoblog. Technicians only need to remove three of the nine fasteners in the wheel housing. Then, peel off the liner and enter the oil filter. Dawn McKenzie, the product communication manager of Ford pickup truck and commercial vehicle, confirmed the correct information and said, "The wheels of 2019 Ford Ranger do not need to be removed when the oil filter is replaced."If the camshaft position sensor is faulty, you can check the camshaft position sensor with an alternative method, and then read the fault code with a diagnostic computer.
If the fault code is reported too many times, it is necessary to replace the camshaft position sensor. The camshaft position sensor is one of the most important sensors in the engine electronic control system.The camshaft position sensor is one of the most important sensors in the engine electronic control system. Its function is to provide the electronic control unit of the trip computer with a signal to determine the piston position, so as to determine the ignition timing and sequential fuel injection of the engine. If the engine lacks or fails to receive the correct position signal from it, it will be difficult to start, unable to accelerate, exceeding the standard, unstable idle speed, etc.
Get a Quote / Info