English 
harley davidson speedometer odometer not working
1. After opening the key door, you need to check whether other information on the instrument is displayed normally. Try to restart the instrument panel to reset the instrument. After resetting, check whether the mileage can be displayed normally.
2. If it still does not show that the vehicle needs to be powered off, try to program the instrument panel after the power failure. If it still fails after programming, there may be a problem with the instrument, and the instrument needs to be replaced.
3. The above two are the reasons and solutions for the meter not displaying the mileage after Harley starts.
If the ABS light is on while driving, it means that there is an abnormality in the ABS electronic control system; Generally, the normal braking system will not cause problems, but the ABS does not work. It does not mean that there is no brake if the ABS is faulty, because they are not connected in series, ABS only it will start when the wheels are about to be locked, and will not start when the wheels are not locked, but as long as the brake system. No faulty brakes are still available, as long as you drive normally; then go to the service station for overhaul as soon as possible.
Step 1: Turn off the ignition switch and remove the guard plate.
Step 2: Pull out the data cable interface with the red cover.
Step 3: Connect the service shorting plug.
Step 4: Turn on the ignition switch and read the fault code (read the fault code in the form of the fault indicator light flashing,
Long flashes represent tens, short flashes represent ones).
Step 5: Eliminate the fault code: (on the premise that the system is not faulty) When the fault light is flashing, within 5 seconds
Unplug the service shorting plug and plug it back in quickly.
Step 6: The fault light flashes quickly for 0.3 seconds, and the fault is successfully eliminated.
How:
1.After the engine is started, there is a knocking sound during low temperature operation. After the temperature is normal, the sound disappears and can be left untreated temporarily, continue running.
2. When the engine temperature is normal, there is an obvious knocking sound. High speed operation should be avoided as far as possible, and the engine should be disassembled and repaired as soon as possible.
3. After removing the cylinder head and pulling out the piston, it is found that the cylinder is seriously out of round, strained, or between the piston and the cylinder. If the clearance is too large, replace the cylinder liner, piston and piston ring.
4. If the connecting rod is found deformed, it should be replaced as much as possible.
Get a Quote / Info