how to tee in water temp gauge

• 2022-11-01

Water temp gauge is used to indicate the coolant temperature. How to tee in water temp gauge ? System composition: temperature sensor (installed on the engine water jacket) and coolant temperature indicator. Classification : electrothermal coolant temperature gauge electrothermal coolant temperature gauge is equipped with electrothermal coolant temperature sensor. The structure principle is similar to that of oil pressure gauge, but the gauge head scale is opposite. The bimetallic sheet indicates low temperature when the deformation is maximum, and high temperature when the deformation is minimum. The normal operating water temperature of the engine should be between 75-90 °C.

The electrothermal coolant thermometer is equipped with a thermistor coolant temperature sensor. The thermistor coolant temperature sensor is mainly composed of thermistor, spring, shell, etc. The lower end of the thermistor is grounded through the shell, and the upper end is connected with the conductive column and terminal through the spring.

The automobile instrument is a device that provides the driver with important information about the operation of the automobile. It is used to indicate the operation of the automobile and the engine, so that problems can be found in time, measures can be taken, accidents can be avoided, and the normal operation of the vehicle can be ensured. It is also an important tool for maintenance personnel to find and remove faults.

When installing the Volkswagen Santana water temp gauge, the owner should first find the water supply pipe of the car. The location is obvious, and the owner can easily see it. Next, cut the opening at a suitable location, and the length should be close to the length of the tee. In this way, the tee can be installed into the water supply pipe and fixed with the lock catch. At the same time, the sensing head can be screwed on the small opening. Finally, this step can be ended by smearing sealant on the gap.

Then, the owner of the car should put the water temperature gauge wire from the left side of the driver's seat to the engine compartment and connect it with the sensor. At the same time, the water temperature gauge wire is connected to the wire in the middle of the cigarette lighter and the other two, so that it can form a circuit with it. The owner can also automatically cut off the power after removing the key, which is very convenient.