English 
lly duramax oil pressure sensor replacement
lly duramax It is a high-end model used by Volkswagen cars to improve performance and reduce gasoline consumption. It is very important to keep the oil pressure within the normal range to ensure vehicle performance. Therefore, when replacing the oil pressure sensor, it is also necessary to operate carefully to ensure that the vehicle operates within the normal range. Here are the steps to replace the oil pressure sensor.
The pressure sensor can be replaced with the original one or a non-original one. The steps to replace the oil pressure sensor are as follows:
1. Drain the oil first, and then remove the oil pressure sensor; 2. Install a new oil pressure sensor on the oil tank; 3. Fill the oil into the oil tank and ensure that the oil pressure sensor 4. Connect the oil pressure sensor to the circuit board and ensure that there is no leakage at the connection; 5. Connect the power supply of the oil pressure sensor and ensure that the power wiring is correct; 6. Finally, turn the oil pressure sensor turn on the power switch of the sensor and check the working status of the oil pressure sensor.
How:
1. First, prepare the necessary tools, namely a ratchet wrench, a piston open-end ring wrench, and a mechanical adapter.
2. Place the piston opening and ratchet wrench on the sensor around the vehicle engine. Take the sensor screw as the center, and use the piston and ratchet wrench to tighten or loosen the sensor screw respectively.
3. Then, remove the sensor from the engine with a piston open ring wrench. Be careful not to touch the connector during the removal process, and maintain the overall stability of the support to avoid damage due to impact.
4. Then, use the mechanical adapter to install the new oil pressure sensor on the engine. During installation, pay attention to that the screws inside and outside the shaft should be installed in strict accordance with the standards marked on the engine, so as to avoid the phenomenon of loose tightening. After installation, it is also necessary to calibrate the coordinates.
5. Finally, after installation, tighten the screws of the new oil pressure sensor with a piston opening and a ratchet wrench to ensure proper tightness, and then start the engine to check whether the oil pressure is within the normal range.
To sum up, replacing the lly duramax oil pressure sensor requires careful operation. Following the above steps, it can be ensured that the replaced oil pressure sensor works normally and the vehicle can operate normally. In addition, for the convenience of vehicle maintenance in the future, the tools needed for sensor replacement should also be prepared for immediate replacement.
Get a Quote / Info