English 
nissan 2000 frontier fuel level gauge meter
The inspection steps of Nissan 2000 frontier fuel level gauge meter are as follows:
1. Check for oil leakage.
2. Drive the vehicle in the city with the engine warm. When the ambient temperature is 20 ° C. At (68 ° F), it takes approximately 10 minutes for the CVT liquid temperature to rise to 50 to 80 ° C (122 to 176 ° F).
3. Park the vehicle on level ground.
4. Apply the parking brake.
5. When the engine is idling, simultaneously press the brake pedal and move the gear selector through all gears. 6. After pressing the lug on the CVT Level sensor to release the lock, pull out the CVT Level sensor from the CVT fluid filler pipe
Warning:
·Do not remove the radiator cap when the engine is hot. Otherwise, the high-pressure engine escaping from the radiator will be cold. Liquid can cause serious burns. take care exceeding the specified test pressure may damage the radiator.
Note:
·When there is a decrease in engine coolant, please fill the radiator with engine coolant. If any parts are found to be damaged, please repair or replace them. Confirmed that the liquid level in the reservoir is within the specified range (between the MAX and MIN lines). MAX-MIN visually inspect for brake fluid leaks around the auxiliary tank, reservoir, and hoses· If the fluid level is very low (low TMTN), check the brake system for leaks.If the warning light remains on even if the parking brake is released, check the brake system for brake fluid leaks.
Note:
Before starting the engine, stop the vehicle horizontally and check the engine oil level. If the engine has started, turn off the engine and wait for 10 minutes before checking.
1. Pull out the oil dipstick and wipe it clean.
2. Insert the oil dipstick and confirm that the engine oil level is within the range. If it exceeds the range, please adjust it.
·Check for white turbidity or severe contamination in the oil.
·If the engine oil appears cloudy and white, it is highly likely that it has been contaminated by the engine coolant. Repair or replace damaged parts.
Get a Quote / Info