English 
glow shift fuel level gauge installation
The fuel level sensor (or gasoline gauge) is a device used to display the amount of gasoline remaining in the vehicle's fuel tank. Glowshift fuel level gauge installation:While these devices are widely used in automobiles, these devices can also be used in any underground storage tanks etc. A car fuel level sensor can be rebuilt without consulting a car dealer.
How to use it? In a car, the unit consists of two parts: a sensor system and a fuel indicator. The sensor unit usually runs on a float that floats above the potentiometer. When the car's gas tank runs dry, the float descends and turns the connection over the resistor, maximizing its resistance. Additionally, once the resistance reaches a certain level, it will also turn on a low gas light on certain cars.
Meanwhile, the fuel indicator system (usually mounted on the dash) calculates and displays the amount of current flowing through the transmission system. Once the fuel level is increased and the optimum current is passed, the gauge reads (f), showing a 100% full car tank. If your tank is dry, the minimum current is moving and the meter reads (e), showing a dry tank.
Step 1 - Turn off the gas and power lines
Lift the rear hatch or open the trunk and take out the spare wheel if you have one. Separate the gas and power cables to the tank.
Step 2 - Separate the Tanks
Loosen the cables using a pair of small screwdrivers, and remove the fuel tank mount. Take out the three bolt supports under the vehicle. Then, gradually move the vehicle's gas tank (a small amount of gasoline makes the tank lighter). You can ask a friend to fetch it for you, each on both ends.
Step 3 - Removing the Transmitter
Remove the clips on the electrical attachment on top of the launcher (the gas line should not be removed at this point as fuel will flow from the tank). Next, using a screwdriver and hammer, rotate the launcher on top of the lockout, locking the cleat and channel. Spray the lock ring with grease and minimize friction when turning. With the locking ring closed, remove the launcher from the tank.
Step 4: Remove the Fuel Level Sensor
Locate the fuel level sensor, which is usually at the very bottom of the launch. Remove clip and slip sensor from harness.
Step 5 - Install New Sensor
When you're shopping for a new fuel level sensor, be sure to check your vehicle's owner's manual to make sure you're buying the right one. Install a new gas level sensor, sliding into the old location. Repeat these steps from last to first to replace the unit in the vehicle tank, and you're done.
Get a Quote / Info