toyota speedometer cable replacement

2023-04-26

1. How to connect the stopwatch, just connect the speed transmission signal line, if not, you can connect the ABS signal line.

2. The stopwatch is also the itinerary adjuster. When the car is stopped, the itinerary can run the number of trips and the speed can be adjusted. It meets the requirements of objective conditions. The electronic itinerary of various models at home and abroad.

3. The stopwatch is used for the adjustment of the vehicle trip meter. It is suitable for all models that use LCD and electronic watches, including domestic and imported cars. The stopwatch has very powerful functions and stable performance. The stopwatch always keeps the stability and reliability first

4. The stopwatch can basically work stably and reliably in a 12V or 24V circuit, so as to adapt to various models. The stopwatch uses three single wires, which are red wire, yellow wire and blue wire. The red wire is Hall signal. The yellow line is the magnetoelectric and ABS signal, and the blue line is the conversion line.

5. The stopwatch meets the requirements of objective conditions. It can be used for Hall signal, dry reed signal, abs output signal, gearbox computer output signal, and the itinerary of supply signal. It can also be used for the generation of frequency signals in the process of vehicle repair, which meets the objective Conditions require a wide range of requirements.

Toyota speedometer cable replacement:Knowing the transmission route of the vehicle speed signal, the wheel speed sensor is used to monitor the wheel rotation speed and send signals to the anti-skid control ECU. The anti-skid control ECU converts these signals into 4 pulse signals and sends them to the ECM through the instrument cluster. The frequency of the pulse signal determines the vehicle speed. Since the indication of the combined instrument is normal, it means that the signal from the anti-skid control ECU is normal. There may be three aspects to analyze the fault location: ①The signal line from the combined instrument to the ECM is faulty; ②The combined instrument is faulty; ③ECM is faulty.

1. Firstly, connect the signal line water of the electronic meter on the Toyota car and the power supply line of the temperature meter.

2. Secondly, connect the two plugged water temperature sensors and connect the signal at one end.

3. The last end is connected to the ground, and the signal line of the watch is F or S or e.