yamaha nytro water temp gauge sensor

• 2022-10-11

The yamaha nytro water temp sensor is one of the important bases for the computer to judge the working condition of the engine at that time. If the temperature of the engine is minus 10 ℃ when it is cold started, but the yamaha nytro water temp gauge sensor "tells" the computer that "the temperature is now 10 ℃", the computer will inject fuel according to the working condition of 10 ℃. Of course, the fuel volume should be small, and the jitter is natural.

The yamaha nytro water temp gauge sensor is an important accessory of the yamaha nytro water temperature gauge. The NIC thermistor chip used for temperature measurement in the previous yamaha nytro water temp gauge sensor generally used a circular NIC thermistor chip. They are calculated by diameter. Now the NIC thermistor chip used by our water temperature sensor is more convenient for welding.

The yamaha nytro water temp gauge sensor is broken in the following ways: 1. The indicator pin of the water temperature gauge does not move and points to the highest position; 2. It is difficult to start the cold vehicle, and the temperature signal of the hot vehicle is displayed. The ecu can not get the signal of too rich mixture, and can only provide the thinner mixture of the engine; 3. Increased fuel consumption and unstable idle speed; 4. It is difficult to accelerate. The engine speed cannot be increased after the accelerator is pressed to the bottom. The sensor is a kind of electronic original device on the automobile circuit. If it is damaged, there is little room for repair, only replacement. If you want to test the yamaha nytro water temp gauge sensor, the simple method is to put the yamaha nytro water temp gauge sensor into the heating cup for heating (don't submerge the plug), and use the "resistance gear" of the multimeter to measure. When the temperature rises, the resistance should be smaller. If there is no change, it means that the sensor is damaged.

If the water temperature sensor is used for a long time, its properties and functions may change, causing errors in the water temperature signal, and adversely affecting the fuel injection, ignition time, and the operation of the fuel pump. However, changes in this property and function data of the water temperature sensor (not short circuit or open circuit) are often not recognized by the self diagnostic system. The sensor needs to be replaced.