harley davidson oil temp gauge 97 sportster

• 2022-09-02

Harley davidson oil temp gauge 97 sportster: A short plug cable is attached with the meter. One end is connected to the meter and the other end is connected to the diagnostic plug on the left cover of the vehicle. Turn on the ignition switch and the meter will display the copying progress, followed by the word "check". After the word "OK", turn off the ignition switch and unplug the plug. You can install a new instrument. Remember to align the meter and tighten the screws.Setting of mileage unit (km / mile): in the total mileage interface, press and hold "trip" switch the mileage unit, "Mile" is miles and "kilo" is kilometers

Setting of fuel level display: press and hold the "trip" button, then turn the key to the accy position (for vehicles without keys, press the ign switch to the on position and then quickly switch to the off position).The on on the meter indicates that the oil quantity display is on. Turning the key back and forth or switching the ign switch back and forth will display the word Gal. Set the corresponding oil tank size (7.98 liters (2.1 gallons) according to the size of the vehicle's oil tank 12.54 liters (3.3 gallons) or 17.1 liters (4.5 gallons)). Long press and hold "trip" to switch to the next display setting or close the key door to save the setting.After the oil level sensor is installed, Lo RNG may be displayed when the fuel level is insufficient or the battery is disconnected and reconnected, which means that the remaining low driving distance. Check the gasoline level. If the gasoline level is normal, the display can be ignored, because the range of the instrument is calculated according to riding habits, and the range will be updated slowly in the next 50 km,Whether the oil level is normal is judged by the level of oil on the oil dipstick.

① is the lowest oil level and ② Is the highest oil level.Dry the oil dipstick with a clean rag, screw the oil cap back to the oil pot clockwise, screw out the oil cap again, and check the oil level on the oil dipstick. It is normal between ① and ②. The oil level can be lower than ① and can be higher than ②.If the oil level can be seen in the cold state, but the level is lower than ①, cover the oil cover, start the engine, run for wait for 2 minutes, and then shut down the engine Check the oil dipstick again and replenish or extract the oil according to the oil dipstick until the oil level is between ① and ② of the oil dipstick.