English 
kus water level gauge 240 ohm
The car water tank, also known as the radiator, is a key component of the car cooling system. The water level in the water tank can be observed at any time through the KUS water level gauge, you can select different signals , such as 240ohm. The function of the water tank is to dissipate heat. The cooling water absorbs the heat from the water jacket, flows to the radiator, dissipates the heat, and then returns to the water jacket for temperature regulation. It is a structural component of a car engine. The solution to clogging of small heating water tanks: The simplest way is to find a good parking lot to clean, then find a repairman to remove the inlet and outlet pipes of the heating water tank, and then use the water gun of the cleaning truck to rinse back and forth until the outflow of water becomes clear. If you receive a scale remover, you can also remove the original antifreeze, add water and scale remover, rinse with water several times after a day or two, and then inject new antifreeze. If it doesn't work, let's see if there's a store that specializes in repairing water tanks. If there is, please send it to the master of the water tank shop to see if it can be cleaned and unblocked for a few yuan. If it can pass, then this water tank can be used for a period of time.
Car radiators should not come into contact with any acid, alkali, or other corrosive substances. Advocate the use of soft water, and soften hard water before use to prevent internal blockage and scaling of the radiator. When using coolant, in order to prevent radiator corrosion, it is necessary to use a long-term rust resistant coolant produced by a reputable manufacturer that meets national standards. During the installation of the heat sink, please do not damage the heat sink strap (plate) or hit the heat sink to ensure heat dissipation capacity and sealing. When the radiator is completely drained and then filled with water, it is necessary to first open the drain switch on the engine block, wait for the water to flow out, and then close it to prevent foaming During normal use, the water level should be checked at any time, and the machine should be shut down for cooling before adding water.
Get a Quote / Info