install water temp gauge chevy 350

• 2023-04-08

Chevy 350 can be equipped with a water temperature gauge, which displays the working temperature of the coolant in the engine cylinder head sleeve. When the coolant temperature rises to near the boiling point (95-98 ℃), the water temperature warning light can light up to attract the driver's attention and drive cautiously. 

After installing the water temperature gauge on Chevy 350, you can observe the working status of the machine at any time. If the temperature reaches 98 or 99 degrees and the electronic fan does not start, turn off the engine and open the machine cover. It's best not to turn on the air conditioning for a long time in summer. If it's not beautiful enough, you can also add turbine pressure gauges, tachometers, etc. There are generally two water temperature sensors. One type is a sensor for a water thermometer, and the other is a wire that displays the temperature of cooling water (or coolant) on the thermometer and regulates the oil supply during startup. Another type is a cooling water or coolant sensor, which is a two wire sensor used to control the coolant of an electronic fan and operates at high temperatures. 

When the power line of the Chevy 350 water temperature gauge is disconnected, the electric heating coil of the water temperature gauge is burned out, the electric heating coil of the water temperature gauge sensor is burned out or the contact is poor, the wiring of the water temperature gauge sensor wire is poor or open, and the stabilizer that supplies stable power to the water temperature gauge circuit is damaged, all of which may cause problems with the display of the water temperature gauge . To confirm if the circuit is normal , turn on the ignition switch and the water temperature gauge connected to the two wires will run, otherwise the circuit is faulty . Then the circuit is confirmed to be normal by the above , and the thermostat is connected. Turn on the ignition switch , and the water temperature gauge will move . Conversely, if the thermostat is faulty , replace it . After starting the car for a period of time , the engine and water temperature can reach normal temperature , and the water temperature is basically stable at around 90 degrees . At this point , the vehicle can be driven normally.