English 
chevy impala fuel level gauge not working
Reasons why the Chevy impala oil gauge does not work:
1. The pointer of the oil gauge is faulty;
2. The oil level sensor is damaged;
3. The connecting rod between the oil level sensor and the float is damaged;
4. The oil level sensor is stained;
5. The oil level sensor The circuit to the ECU has an open circuit or a virtual connection;
6. The sliding resistance of the fuel position sensor is poorly connected or severely worn;
7. The instrument circuit is abnormal or the electrical components are aging due to a virtual connection.
If the fuel gauge remains full, it is a good thing for the car owner, indicating that the fuel tank is full. However, if the fuel gauge remains full, it is abnormal for a long time, which may be related to these reasons.
1. The fuel gauge is broken. If it is not just after filling up the oil, the fuel gauge is full, but the car has been used for a long time after refueling, and there is still such a situation, it may be caused by the fuel gauge being broken, and it needs to be repaired in time or replace.
2. The oil level sensor is broken. The oil level sensor is a device inside the fuel tank, but the oil level sensor will be damaged due to excessive use time, etc. This situation will also cause inaccurate display of the fuel gauge value, and may cause the fuel gauge to remain full.
3. The oil quantity sensor is stuck. If this is the case, reinstalling it can restore the value of the oil gauge to normal.
4. The fuel tank has not been cleaned for a long time. There is a certain amount of inert gas in the closed fuel tank. After the car has been used for a period of time, it is necessary to clean the fuel tank of the car to keep the inside of the fuel tank clean and the gasoline clean. fuel gauge value.
Tips on how to turn off the oil change of Chevrolet:
(1). When the engine is turned off, turn on the ignition switch and put it in the power-on mode.
(2) . Use the button in the driver information center area on the right side of the steering wheel to control the instrument panel display to display the oil life interface. When the remaining oil service life is low, the message "Please change the oil quickly" will be displayed on the display.
(3) . Press the button on the driver information center controller, the display will display reset, and then press the (OK/Confirm) button to reset the oil life to 100%
(4). Turn off the ignition switch, and the reset is complete.
Get a Quote / Info