English 
harley oil level and oil temp gauge dipstick
Harley the bottom of the oil cover is the oil dipstick, which can judge whether the oil level is normal by the liquid level of the oil on the oil dipstick.
① is the lowest oil level and
② is the highest oil level
Dry the oil dipstick with a clean cloth, screw the oil cover back to the oil pot clockwise, screw out the oil cover again, and check the oil level on the oil dipstick It is normal between positions ① and ②, and the oil level shall not be lower than ① or higher than ②
If the oil level can be seen in the cold state, but the level is lower than ①, cover the oil cover, start the engine, run for one to two minutes and then turn off the engine .Check the oil dipstick again and replenish or extract the oil according to the oil dipstick until the oil level is between the positions of oil dipstick ① and ②
Sometimes, when the temperature is high or riding in time, some oil stains will be seen on the air filter, especially when the flow air filter is modified Generally, you don't have to worry too much about the abnormality of the vehicle. Wipe out the leaked engine oil and pay attention to the engine oil level to ensure that there is no loss of engine oil Locate the oil dipstick. The oil scale is usually next to the engine, some on the top and some on the side. The scale has an obvious feature, that is, there is a hand pull ring to pull out the oil scale. Note that it is useless to check the oil quantity when the vehicle is cold. If you just drive back or the engine is running. Use the oil dipstick to see the oil of the motorcycle. Generally, the oil dipstick is inserted and then taken out to see, rather than screwed up and installed and then taken out to see. As long as the oil level is between the upper and lower scales, if the oil is in Zone A, do not add oil. If the oil is in zone B, you can add oil. If the oil is in Zone C, you must add oil. Note that zone B is what we usually call the pitting area. Zone A is from the top of the pitting point to the bending part of the oil dipstick, and Zone C is from the bottom of the pitting point to the bending part of the oil dipstick.
Pull out the oil dipstick and you can see the amount of oil on the dipstick. If the oil quantity is between the upper limit and the lower limit, the oil quantity is normal. The so-called upper and lower limits are generally marked, which can be clearly seen.
Get a Quote / Info