English 
ford a radiator cap water level gauge
Generally, there is no ford a radiator cap water level gauge in the water tank. The water filling pot of the water tank has a water level alarm light. As long as the water in the kettle is not less than the minimum level , the water tank will not be short of water. You'd better keep it at the highest mark . A water level gauge can be installed to observe the water level at any time.
The ford a radiator cap shall not contact with any acid, alkali or other corrosive properties. It is recommended to use soft water, and hard water should be softened before use to avoid the internal blockage of radiator and the generation of scale. When using the antifreeze, in order to avoid the corrosion of the radiator, please be sure to use the long-term anti rust antifreeze produced by the regular manufacturer and meeting the national standard. During the installation of the ford a radiator cap, please do not damage the radiator fins or damage the radiator to ensure the heat dissipation capacity and sealing. When the radiator is completely drained and refilled, turn on the water drain switch of the engine block first, and then turn it off when there is water flowing out, so as to avoid water bubbles. Check the water level at any time during daily use, and add water after shutdown for cooling.
When adding water in ford a radiator cap water level gauge, slowly open the water tank cover, and keep the operator as far away from the water inlet as possible to prevent scalding caused by high-pressure steam spraying from the water inlet. In winter, in order to prevent core fracture caused by icing, such as long-term shutdown or indirect shutdown, the water tank cover and drain switch shall be used to drain all water. The effective environment of the standby radiator shall be ventilated and dry. Depending on the actual situation, the user shall completely clean the core of the radiator once within 1-3 months. When cleaning, use clean water to wash along the reverse wind direction. Regular and complete cleaning can prevent the radiator core from being blocked by dirt, which will affect the heat dissipation performance and the service life of the radiator. The water level gauge shall be cleaned every 3 months or as the case may be; Remove all components and clean them with warm water and non corrosive detergent.
Get a Quote / Info