easiest way to install manual water temp gauge

• 2023-09-15

Installing a water temperature gauge in three steps is the easiest and most practical. I learned from the 4S store that the weather has been heating up severely recently, and many cars have been boiling over. Moreover, most models are on highways, and if a vehicle malfunction occurs at a speed of 120 kilometers per hour, no one wants it to happen. In the eyes of most drivers, a water temperature gauge is optional. Some people respond by saying, "If a malfunction occurs, the vehicle will alarm, whether it is necessary or not", but most mid to high-end models have a water temperature gauge, This way you can see the basic information of the car model, so this episode will teach you how to simply install a water temperature gauge. 

Firstly, there must be a car. Secondly: online shopping tee (28mm), water temperature gauge, sealant, temperature sensing head, and multi point cigarette lighter. Finally: 1. Find the water supply pipe, which is usually 28mm and is very obvious in the carriage. Cut the opening length as close to but not more than the length of the tee at a suitable position . 2、 Install the tee into the water supply pipe and tighten it with a locking buckle. Screw in the sensing head at the small opening and apply sealant to the gap . 3、 Thread the wire of the water temperature gauge from the left side of the driver's seat to the engine compartment and connect it to the sensor . 4、 Connect one of the water temperature gauges to the middle one of the cigarette lighter , and connect the other two randomly to form a circuit. After removing the key, it can automatically cut off the power. The great success has been achieved . After installing a water temperature gauge, the mechanical working status can be observed at any time. If the temperature reaches 98 or 99 degrees Celsius and the electronic fan does not start, then turn off the engine and open the machine cover to rest. It is best not to turn on the air conditioning for a long time in summer, as it is not good for the car and people. If it doesn't look beautiful enough, you can also add a turbine pressure gauge, Tachometer, etc. The more the gauges, the higher the level.